This repository contains my personal RepRapFirmware configuration files (sys folder), custom macros, and other items for the Rook MK2 3D printer by Rolohaun Design and Kanrog.
Official Rook MK2 Mods Collection
- Printer: Rook MK2
- Mainboard: BTT SKR3 EZ
- Firmware: RepRapFirmware (RRF) by TeamGloomy
- Fans: Fan connections utilize standard Female JST-XH connectors. Check your board's pinout before connecting.
- Tuning: Ensure you perform a dedicated extruder calibration (adjusting e-steps) first, before moving on to separate flow rate tests, as these parameters are tuned independently in this config.
All configuration files (.g files), macros, and documentation in this repository are created by rexit and are licensed under the Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License (CC BY-NC-SA 4.0).
What this means:
- Share: You are free to copy and redistribute the material in any medium or format.
- Adapt: You can remix, transform, and build upon the material.
- Attribution: You must give appropriate credit, provide a link to the license, and indicate if changes were made.
- NonCommercial: You may not use the material for commercial purposes (you cannot sell these configs or put them behind a paywall).
- ShareAlike: If you remix, transform, or build upon the material, you must distribute your contributions under the same license as the original.
To view a full copy of this license, visit: http://creativecommons.org/licenses/by-nc-sa/4.0/